Advertisement
Installation & Basic Connections
• Use an Ethernet cable to connect the HDBaseT
TM
OUT jack on one of the following of our AV receivers to the HDBaseT jack on this unit to transfer video, audio, and control signals.
(DRX-4/DRX-5/DRX-7/DRX-R1/DRC-R1/DRX-7.1/DRX-R1.1/DRC-R1.1, and models supporting HDBaseT
• When using one of our AV receivers that supports Power over Cable (PoC), it is also possible to supply this unit with power over the Ethernet cable.
When installing on the floor
When installing on the floor, use the supplied cushions to
help prevent damage to the floor.
Cushions
When installing on a wall
Fix this unit with the supplied screws for wall attachment
when installing on a wall.
Screws for wall
attachment
• Do not attach to the ceiling.
• After attaching, check that the fitting is secure. We accept
no responsibility for damage or injury that arises due to
incorrect attachment.
TM
OUT sold in 2018 and thereafter)
AV Receiver
Only when using
a device that
supports PoC
3.
4.
1.
Connect this unit to a monitor such as a TV or projector using an HDMI cable.
2.
Connect this unit to one of our AV receivers using an Ethernet cable.
3.
Set the ON/OFF switch on the rear of the AV receiver to ON.
4, 5.
Connect the AC adaptor.
If a device that does not support Power over Cable (PoC) is connected, connect the
＊
AC adaptor to the 12V 1A INPUT jack on the rear of the unit.
TV, Projector
1.
2.
HDMI cable
Ethernet cable
5.
AC adaptor
Other Connections
RS232 Connections
This is an example of connecting to a home control system with an RS232 cable.
Also read the instruction manual supplied with the connected device.
AV Receiver
Ethernet cable
RS232 cable
RS232 cable
Home control system
TV, etc.
IR Connections
This is an example of connection to an IR receiver.
Also read the instruction manual supplied with the connected device.
AV Receiver
Ethernet cable
IR Receiver
TV, etc.
(C) Copyright 2017 Onkyo & Pioneer Corporation Japan. All rights reserved.
IR system cable
Printed in Malaysia
Advertisement
