Table of Contents
Advertisement
IDENTIFICATION OF CONTROLS
FRONT PANEL
av surround sound preamp processor
2
1 o (STANDBY)
•
Press o (Standby) button for the M17 to be switched ON from
standby mode. The Power indicator will turn from amber to bright/
white color.
•
Pressing o (Standby) button again switches back M17 to standby
mode. The Power indicator will illuminate to amber color at standby
mode.
•
The o (Standby) button cannot activate the M17 with the rear
panel POWER switched off.
IMPORTANT NOTES
•
Refer also to +12V TRIGGER IN (OFF/AUTO) of IDENTIFICATION OF
CONTROLS – REAR PANEL.
•
For the o (Standby) button to activate, two conditions must be
completed.
a. Plug-in the supplied mains power cord to a mains power source.
Connect corresponding end of the mains power cord to the AC
mains input of M17 and the plug connected to a mains power
source.
b. The rear panel POWER switch must be set to ON position.
2 POWER INDICATOR
•
This indicator will light up amber when the M17 is at standby mode.
•
When M17 is powered up from standby mode, this indicator will
turn from amber to bright/white color.
3 REMOTE SENSOR
•
Point the HTRM 2 remote control at the remote sensor and press
the buttons.
•
Do not expose the remote sensor of the M17 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the M17 with the remote control.
Distance: About 23ft (7m) from the front of the remote sensor.
Angle: About 30° in each direction of the front of the remote sensor.
6
1
M17
3
4
4 DISPLAY
•
•
•
•
The following are sample screenshots of the four display options with
corresponding description of the information shown.
MAIN
Source 1: Current Source.
-20.0 dB: Volume level.
Dolby Atmos: Audio Codec - Detected audio stream format.
HDMI 1/HDMI 1: Audio and video input source.
Object 48k: Audio Source format; sample rate.
1920x1080i60 24 bit RGB 4:4:4: Video mode - Video resolution of
current source with frame rate.
Information is displayed as supplied by the applicable source.
There are five display options – Main, Listen, Dirac, Tone and Zone.
Use your finger to press and select any of these display options to
show their corresponding menu options or settings.
Refer also to the item about DISPLAY SETUP under the USING THE
M17 - SETUP MENU segment of the OPERATION section.
: Go to previous or next Source.
© NAD M17
5
Advertisement
Table of Contents
