Table of Contents
Advertisement
WHAT'S IN THE BOX
Packed with your M17 you will find
•
Quick Setup Guide
•
BluOS Kit containing USB Hub, Wi-Fi Dongle, Bluetooth USB Micro
Adapter and USB to USB Cable Extender
•
HTRM 2 remote control with 4 AA batteries
•
BluOS-Ready Flyer/Bluesound player
•
ZR 7 zone remote control with 3V CR2025 battery
•
Measurement microphone with USB Mic adapter and phone jack
adapter
•
Detachable mains power cord
•
Four pieces of magnetic feet
•
Four female 3-pin mini-XLR to male 3-pin XLR cables
•
Cleaning cloth
•
USB flash drive
SAVE THE PACKAGING
Please save the box and all of the packaging in which your M17 arrived.
Should you move or otherwise need to transport your M17, this is by far
the safest container in which to do so. We've seen too many otherwise
perfect components damaged in transit for lack of a proper shipping
carton, so please: Save that box!
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to
both sides and behind), and that will provide a clear line of sight, within
25 feet/8 meters, between the M17's front panel and your primary
listening/viewing position - this will ensure reliable infrared remote control
communications. The M17 generates a modest amount of heat, but
nothing that should trouble adjacent components.
DEFAULT SOURCE SETTINGS
The following table lists the default SOURCE settings. Note that the Audio
input settings show both digital and analog audio input. Digital input will
always take precedence over analog audio input even if both are present.
SOURCE
AUDIO INPUT
Source 1
HDMI 1/Stereo 1
Source 2
HDMI 2/Stereo 2
Source 3
HDMI 3/Stereo 3
Source 4
HDMI 4/Stereo 4
Source 5
HDMI 5/Stereo 5
Source 6 (BluOS)
BluOS
To modify the above default settings and for a better understanding of
source setting and combinations, please refer to the item about "SOURCE
SETUP" in the "USING THE M17 - SETUP MENU" segment of the "OPERATION"
section.
NOTE
Digital input will always take precedence over analog audio input if
both are present.
RESTORING M17 TO ITS FACTORY DEFAULT SETTINGS
1 Press and hold front panel's "Main" display.
2 Select "Setup" display option.
3 Select "Factory Reset" display option.
4 Select between "Yes (NTSC)" and "Yes (PAL) to select video mode after
Factory Reset. Select "No" if you decide not to reset your M17.
VIDEO INPUT
HDMI 1
HDMI 2
HDMI 3
HDMI 4
5 Factory reset is complete after the display below and the M17 going to
HDMI 5
standby mode.
BluOS
INTRODUCTION
GETTING STARTED
5
Advertisement
Table of Contents
