Table of Contents
Advertisement
P P R R O O G G R R A A M M
C C L L E E A A R R
E E Q Q
T T O O N N E E
D D I I M M M M E E R R
ADJUSTING CHANNEL LEVELS 'ON THE FLY'
CHANNEL VOLUME
You can make changes to the relative levels of center, surround and
subwoofer outputs without having to go into the "Speaker Levels" menu.
This is very convenient in circumstances like increasing (or tone down)
a film's dialog level by raising (lowering) the center channel or reducing
excessive deep bass (or enhance deep bass) by lowering (raising) the
subwoofer level.
HTRM 2
Use the HTRM 2's "SURR, ' 'CENT" and "SUB" keys for direct-access level
adjustment of these channels over a range of ±6 dB.
The surround back channels (if any) adjust in lockstep with the surround
channels.
ZONE SETUP
The Zone feature allows one to simultaneously experience in different
zones of the house multiple sound sources from all enabled analog
Sources.
The M17 has three configurable Zones – Zone 2, Zone 3 and Zone 4.
ZONE 2 SETUP
VOLUME MODE
Zone 2 has Fixed and Variable volume control modes.
Variable: Zone 2 Volume level can be adjusted using HTRM 2's [D/F]
or directly via ZR 7's [VOL d/f].
Fixed: Zone 2 Volume is set to a preset dB level using HTRM 2's [D/F]
and thereafter Zone 2's volume level can be varied via the volume
control of the separate amplifier it is fed into.
See discussion also about "Zone Controls" at the Main Menu.
R R E E P P E E A A T T
L L . . N N I I T T E E
ZONE 3 SETUP/ZONE 4 SETUP
MODE
Zone 3 and Zone 4 can be configured into two modes - Record and Zone.
See discussion also about "Zone Controls" at the Main Menu.
NOTE
TRIGGER SETUP
The M17 features three configurable +12V DC Trigger Output that can be
used to activate a component or system it is fed into. A Trigger Input can
also be configured to turn ON/OFF a section of M17.
USING THE M17 – SETUP MENU
Record: ZONE 3 OUT/ZONE 4 OUT is used as a regular AUDIO 3 OUT/
AUDIO 4 OUT ports. Audio present at AUDIO 3 OUT or AUDIO 4 OUT
jack is determined by the current Main Source. There will be no output
at AUDIO 3 OUT if the current Source is analog Source 3. Likewise, there
will be no output at AUDIO 4 OUT if the current Source is analog Source
4. This prevents feedback through the recording component thereby
preventing possible damage to your speakers.
Zone: ZONE 3/ZONE 4 becomes available and configurable at the
"Zone Controls" window of the Main Menu. Zone 3 and Zone 4 can be
configured the same way as that of Zone 2 Setup menu above.
The ZR 7 remote control will only control Zone 2 applications.
OPERATION
19
Advertisement
Table of Contents
