NAD M17 Owner's Manual page 24

OPERATION
USING THE M17 – SETUP MENU
2 With the above settings, scroll to "A/V Presets" from the SETUP MENU
page. Use [S] to access "A/V Presets" menu.
3 At "A/V Presets" page, set "Preset: 1" to the following conditions – use
[D/F] to select "Yes" and press [ENTER] to confirm selection and move
on to the next setting.
While at "Save Current Setup to Preset" menu line, use [S] to save the
above settings to Preset 1. Below OSD will be shown, affirming that the
above settings are now saved to "Preset 1".
When you recall "Preset 1" using the remote control (for HTRM 2, "A/V
PSET"+ "1"), the above preset values allocated at "Preset 1" (preset
settings as shown in the OSD captures at Step 1) will be recalled and
effected at the current source.
4 Now, repeat again Step 1 above but this time with the following
settings
Listening Mode Setup: Listening Modes/Dolby Digital/Stereo/None
24
Dirac Live: Dirac Project 1
Tone Controls: Tone Defeat/On
5 With the above settings, scroll to "A/V Presets" from the SETUP MENU
page. Use [S] to access "A/V Presets" menu.
6 At "A/V Presets" page, set "Preset: 2" to the following conditions - use
[D/F] to select "Yes" or "No" and press [ENTER] to confirm selection and
move to the next setting.
While at "Save Current Setup to Preset" menu line, use [S] to save the
settings above to "Preset 2". When you recall "Preset 2" using the remote
control (for HTRM 2, "A/V PSET"+ "2"), the above preset values allocated
at "Preset 2" (preset settings as shown in the OSD captures at Step 4) will
be recalled and effected at the current source.
Note that "Speaker Setup" is set to "No". At this condition, there will
be no "Speaker Setup" values that will be effected at "Preset 2". The
"Speaker Setup" settings that will be applied at "Preset 2" will be the last
or current "Speaker Setup" settings which in this sample are the same
"Speaker Setup" settings shown above in Step 1. The same applies for
"Front Panel Display Setup" which is also set to "No".