NEC Express 5800 Series User Manual page 55

<target> modify drives=[#:]#:#-[#:]#:#
where <target> is an array, and the specified physical drives are the new destination for the array.
For example, in an existing array, three 72-GB SAS drives (1e:1:4-1e:1:6) are the source. Another drive of the
same size is the spare (1e:1:9). With all criteria met, you can move the array to three different 72-GB SAS
drives by specifying the new destination drives in the command (1e:1:12-1e:1:14). To maintain the same
spare drive, be sure to designate the spare drive for the moved array.
Example commands:
=> array a modify drives=1e:1:12-1e:1:14
=> array b modify drives=1c:1:6-1c:1:7
Replacing an array
You can replace an array by designating different physical drives for the array. To replace the array, each of
the physical drives where the array will reside must meet the following criteria:

The destination drives must all be the same type (for example, SATA or SAS), but do not have to be
same type as the drives in the source array.

A destination drive does not have to be an unassigned drive, but if it is assigned, it must be a drive
assigned to the array being replaced.

The destination drives must have sufficient capacity to hold all the logical drives present in the source
array.
Like array creation and expansion, the useable space in all drives is reduced to the size of the smallest
physical drive in the destination disk set.
Replacing an array automatically removes any previously assigned spare drives. If spares are assigned to the
existing array, they must be designated for the array when it is moved.
Syntax:
<target> modify drives=[#:]#:#-[#:]#:#
where <target> is an array, and the specified physical drives are the new destination for the array.
For example, in an existing array, three 72-GB SAS drives (1e:1:4-1e:1:6) are the source. Another drive of the
same size is the spare (1e:1:9). With all criteria met, you can move the array to three different 72-GB SAS or
SATA drives by specifying the new destination drives in the command (1e:1:12-1e:1:14). To maintain the
same spare drive, be sure to designate the spare drive for the moved array.
Example commands:
=> array a modify drives=1e:1:12-1e:1:14
=> array b modify drives=1c:1:6-1c:1:7
Setting Auto RAID 0
Auto Array RAID 0 creates a single RAID 0 volume on each physical drive specified, enabling the user to
select multiple drives and configure as RAID 0 simultaneously. Each array contains one physical drive and
one RAID 0 logical drive.
Example command:
=> ctrl slot=1 create type=arrayr0 drives=allunassigned
Extending a logical drive
If the operating system supports logical drive extension, you can use any unassigned capacity on an array to
enlarge one or more of the logical drives on the array.
IMPORTANT: An array expansion, logical drive extension, or logical drive migration takes about
15 minutes per gigabyte. While this process is occurring, no other expansion, extension, or
migration can occur simultaneously on the same controller. Controllers that do not support a
battery-backed write cache do not support this process.
SSA CLI 55