Before You Begin - Razor POWER A 2 Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your scooter
was assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 4 hours for charge (see page 6 for charging information).
Charger
(Note: Charger design may
vary from one shown)
Throttle
Quick-Release Lever
Collar Clamp
Required Tool
5 mm
Allen Wrench
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
2.
Anti-Rattle Folding Mechanism
ON/OFF Button
Kickstand
1. Product ID
Power Cutoff Fender Brake
Charger Port
Hub Motor
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void the
warranty.
Note: Electric scooter must
be moving at least 3 mph (5 km/h)
while applying throttle to
engage motor.
Product ID Locations:
(See locations to the left)
1. Underneath Product
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• Power A
2
• Charger
• Owner's Manual
• Allen Wrench