Table of Contents
Advertisement
EN
INSTALLATION AND CONNECTION
RI-840 Wireless in ear UHF belt-pack monitor receiver with earphones
1.- Insert the batteries in the battery compartment respecting the polarity indicated on it. If rechargeable
batteries have been used, they can be recharged following the instructions in the Rechargeable battery
section.
2.- Connect the earphones to the headphone output. If you wish to record a signal received by the receiver
RI-840, connect a recording device to the headphone output or use an adapter to be able to use the
headphone signal and the recorder simultaneously.
3.- Select the type of headphone output signal required with the HEADPHONES OUTPUT selector, single
(mono) or double (stereo).
MSHT-40M Wireless hand-held transmitter microphone
1.- Insert the batteries in the battery compartment respecting the polarity indicated on it. If rechargeable
batteries have been used, they can be recharged following the instructions in the Rechargeable battery
section .
2.- Adjust the sensitivity of the audio input using the GAIN control.
MSHT-45P Tie-clip microphone with wireless belt-pack transmitter
1.- Insert the batteries in the battery compartment respecting the polarity indicated on it. If rechargeable
batteries have been used, they can be recharged following the instructions in the Rechargeable battery
section .
2.- Connect the tie-clip microphone or the required audio source.
3.- Place the selector on the rear part of the tie-clip microphone in the LINE or MIC position depending
on the type of signal you have connected to the input. Select LINE if connected to an audio source
with line level or MIC if connected to a microphone.
TSI-40 UHF transmitter for desktop or installing in 1 U 19" rack
1.- Connect the audio sources on the rear of the transmitter and the mains adapter provided. Place the
selector on the rear part of the device in the 0 dB or -20 dB position depending on the type of signal
that you have connected to the AF IN (L) and AF IN (R) inputs. Position the selector in 0 dB for a
source with line level and in -20 dB if a microphone was connected.
2-
Place the device on a flat surface or in a 19" rack using the mounts supplied with the device.
- 8 -
Advertisement
Table of Contents
