Table of Contents
Advertisement
Installation Instructions (cont.)
A) SET THE TIME OF DAY
1. Press the "SET CLOCK" button
a. The upper left of the display will show "SET TIME"
b. The hour will flash
2. Press the "UP" or "DOWN" buttons (triangle pointing up or down) until the correct
combination of hour and "AM" or "P M" is reached to match the current time.
3. Press the "NEXT" button
The upper left of the display will show "SET TIME"
a.
b. The minutes will flash
4. Press the "UP" or "DOWN" buttons until the minutes match the current time.
5. Press the "NEXT" button
a. The upper left of the display will show "TIME"
b. The current time of day will be shown on the right side of the display
c. Only the colon between the hour and minutes will be flashing.
B) Enter Programming:
simultaneously for 3 seconds.
1. Regeneration Days:
a. The upper left of the display will show "SET"
b. The lower left of the display will show "REGEN" above and "DAY" below.
c. A number will flash (default 3)
2. Using the "UP" or "DOWN" (triangle pointing up or down) buttons, set the number
of days (default 3, recommended) between regenerations.
3. Regeneration Time: Press the "NEXT" button
a. The upper left of the display will show "SET TIME"
b. The middle left of the display will show "REGEN"
c. The hour will flash
4. Regeneration Hour: Using the "UP" or "DOWN" buttons, set the combination of
hour of day and "AM" or "P M" (NOTE: letter spacing as shown on the display)
that the BACKWASH cycle of regeneration should occur. Make sure the filter is
not regenerating at the same time with any other water treatment equipment.
5. Press the "NEXT" button
a. The upper left of the display will show "SET TIME"
b. The middle left of the display will show "REGEN"
c. The minutes will flash
6. Regeneration Minutes: Using the "UP" or "DOWN" buttons, set the minutes
portion of the time when regeneration should occur.
Press "NEXT" and "UP" (triangle pointing up) buttons
8
Advertisement
Table of Contents
