Table of Contents
Advertisement
WARNING
Firmly fixate the product
considering the installation
support, product weight (21kg)
and the vibration so that it does
not shake.
M8, spring washer and nut.]
21kg
• It can cause an injury if the
product falls.
Configure the switchboard to
electric capacity (7A) for each set.
Current
capacity
• Always ground the product as it can
7A
cause an electric shock or a fire.
• When using SSR, install the
product according to 20A capacity
specification per set.
Install earth leakage breaker and
exclusive switch.
• It can cause fire and electric shock
if not installed.
Earth leakage
Exclusive
switch
breaker
Electric work has to be done by
certified technicians by technical
regulation on electric equipment or
indoor wiring specification and
regulation, and this installation guide.
A specific circuit has be used.
• It can cause fire and electric shock if
power capacity is inadequate or
electric work is faulty
CAUTION
Do not install the product
where it not ventilated well.
• It can cause heating of the
product or a fire.
When laying down the product on
the floor, put it in the same
direction as shown in the picture.
• If not laid as shown in the picture, it
can cause product damage.
[Always use fixating bolt
Use the product at rated
specification.
Within
• It can cause a fire or product
±10%
damage.
After installing and fixating the
product, do not block the product
with alien material (Vinyl, silicon
etc.) as shown on the left.
• It can block the inlet/outlet installed
below the power supply and
damage the system.
Please do earth work.
• It can cause electric shock if not
do the earth work
Do not use any heating device
or flammable material within
1m of the product.
• It can cause a fire or an
explosion.
Keep 30cm of clearance
from the case to the wall to
safely use the product.
• It can cause heating of the
product.
5
Advertisement
Table of Contents
