Case lower
– Refer to the dimension of the case below the power supply and fixate the product.
Bolt/Nut connection
(Hole with width of 10mm)
Base plate to fixate product
(Separately manufactured)
– Considering the safety of the system and installation, it is recommended to
manufacture the base plate separately to fixate the product. Refer to the
following drawing. (Not included in the product)
– If the base plate is not required, install the product by considering the cooling
path (Inlet/Outlet) of the system.
30,0
12,0
255,0
• When manufacturing the base plate to
fixate the product, always use steel
plate of L400xW272 (mm) 5T or above.
(Units : mm)
(Units : mm)
Inlet
231
10
252
Outlet
13
11