Lennox ComfortSense 7500 User Manual page 4

E. This allows you to set the heat-to (if enabled)
temperature. Selecting
temperature dial position indicator will take you
to the temperature setting detail screen. The
temperature dial will change from white to red
when heating is active.
F. This allows you to set the cool-to (if enabled)
temperature. Selecting
temperature dial position indicator will take you
to the temperature setting detail screen. The
dial will change from white to blue when cooling
is active.
G. Indicates the current indoor humidity percentage
in the home along with a humidity icon (rain
drop). The icon changes based on the humidity
level in the home.
H. This location could
air temperature. What is displayed in that
location depends on what sensor is installed
and configured through the thermostat user
interface. If neither is installed, then this area
will be blank.
I. Displays the current indoor temperature.
J. Indicates the schedule is on hold until the next
time period or permanent.
• Place the schedule on hold by touching on
either the heat-to or cool-to location on the
screen. If an adjustment is required for the
temperature setting, this can be done now.
• After approximately three seconds the
screen will display the override setting
options.
• From the override setting screen, the
options are 1 hour, 2 hour or next scheduled
period. Make selection and then touch set.
the heat-to or
the cool-to or
display the outdoor
• For the 1 or 2 hour setting the home
screen will indicate schedule hold until time
indicated (i.e., 11:57 pm). To exit schedule
hold, touch X
• When until next period is selected, the set
point will be kept until the next program
schedule period. To exit until next period,
touch X.
K. System Status Icons - Equipment operation
information appears along the left side of the
home screen. The displayed icons will indicate
cooling or heating demand, cooling compressor
delay, or cooling demand.
Table 1. System Status Icons
Description
Icon
NOTE: Touching the icon will display a
Humidifying icon is displayed when
humidifying is occurring. Touching on the
icon will display humidifying next to the
icon.
Dehumidifying icon is displayed when
dehumidifying is occurring. Touching the
icon will display dehumidifying next to the
icon.
Red flames indicates the system is
heating.
Blue flames indicates the system is
cooling.
4
text description.