Interval
Where?
First after 200
operatingm
hours, then
every 2000
operating hours
US
BF46 Vario | BF46TC
Page 48
What?
How?
For oil change use an appropriate collecting tray of suffi-
cient capacity.
Have the mill drill run for a few minutes, the oil will heat up
and will slightly penetrate from the opening.
Remove the ventilation screw from the gear.
Remove the oil drain plug.
Refill the oil over the removed ventilation screw.
Quantity and type of oil
Oil change
Ventilation screw of the gear
Original operating instructions
"Operating material" on page 18
Oil drain plug
Fig.5-3: Milling head
Version 1.1.4 dated 2015-3-30