Input Connections; Output Connections - B&K AV1260 Owner's Manual

Each pair of amplifier channels have their own 'Local' input and output RCA connectors. The inputs are designed
to accept line level audio from a preamplifiers unbalanced output connectors. Output expansion is accommodated
with the supplied output connectors. These outputs are effectively a direct pass through from the inputs.
Typical input setup:
Figure 3 shows 'Local' OUT 1 and 2 connections and how they may be used to connect to another amplifier. OUT
1 source is the same signal as IN 1. OUT 2 source is the same signal as IN 2. BUS inputs are buffered and sent
to the BUS outputs.
The AV1260 connects to speakers via six plug-in Phoenix connectors. Simply unplug the connector
from the rear of the AV1260, strip the speaker wire approximately ¼" and insert the bare end into the
gate on the connector. Use a small flat blade screwdriver to tighten the connection to each conductor.
Make sure you hold the connector upside down to connect Left and Right as shown:
Typical amplifier hookup:

INPUT CONNECTIONS

Figure 3

OUTPUT CONNECTIONS

Figure 5
6