Advertisement
Pack contents check
E
D
A
B
A. Rear Boom x 1
D. Mast Clamp x 1
B. Front Boom x 1
E. Dipole Cap x 1
C. Reflector x 1
F. Dipole x 1
Assembly
1.
Join the 2 pieces of boom together using the
joining plate, M5 x 20mm screws M5 nuts and
5mm Shake Proof Washers.
G
I
H
C
G. Joining Plate x 2
J. M5 Screw x 2
H. Shake Proof Washer x 2
K. 6½ Screw x 1
I. Nut x 2
2.
Screw on firmly the Dipole to the Boom.
3.
F
J
Slide on and firmly push down the Reflector onto
K
the groove of the Reflector Bung.
Connecting Coaxial Cable (not supplied)
1.
Outer
10mm
braid
Inner
core
Thread coaxial cable through Dipole Cap. Strip
away 25mm of outer insulator. Gather outer braid
strands and twist together. Remove 10mm of
inner insulation around inner core.
Polarisation
Tip: Look at outdoor aerials
in your area to see which
direction to point your
aerial for best reception.
Note model
shown different.
For example only.
4.
Attach aerial to a suitable mast using the
supplied Mast Clamp. (Note: Mast not supplied).
2.
25mm
Inner
Foil
Outer
insulator
insulator
Loosen the screws on the 2 terminals in the
Dipole. Feed the inner core to one of the
terminals and the twisted braid into the other.
Tighten screws and close Dipole Cap.
Horizontal mounting
recommended for
Main TV transmitters.
Vertical mounting
recommended for
Relay TV transmitters.
Advertisement
