Page 1
I Helpline: +44 (0) 1553 811000 CAI/AB047 I Email: cust_serv@maxview.co.uk MX50W2 I Visit: www.maxview.co.uk PLEASE NOTE - YOU WILL REQUIRE COAXIAL CABLE TO COMPLETE THE ASSEMBLY OF THIS AERIAL. 9111302 Iss 1 Maxview reserve the right to change specifications without prior notice...
Page 2
I Observe safe working practices, tread carefully and ensure adequate lighting is available in loft Visit our website or roof space. www.maxview.co.uk I To avoid injury always route cables or wiring carefully. for our full range of I Always follow manufacturer’s operating and safety instructions before using tools and/or equipment.
Page 3
Joining Plate and Screws. Element Clips using your thumb. mount bracket. TYPICAL AERIAL MOUNTING APPLICATION EXAMPLES WALL, LOFT & CHIMNEY FIXING KITS ARE AVAILABLE FROM MAXVIEW Wall mounted Loft mounted Chimney mounted Screw the 11 sets of Foil ‘V’ Elements Screw the Element to the Boom.
Page 4
Screw the Dipole to the Boom. Prise open clip using a screwdriver or by hand. Firmly insert Rod into Clip Place the Bungs on the Rods and Boom. cavity and close. CONNECTING COAXIAL CABLE (NOT SUPPLIED) 12mm 18mm 28mm Use the template on the back of the box as a guide to centre the Clips onto the Rod. Using a sharp knife prepare the Loosen the screws on the two terminals.