Drive Belt - Yamaha G-Max G22A Owner's And Operator's Manual

MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
8-7
Inspection and cleaning:
3. Wash the foam pre-filter in soap
and water. Allow it to dry.
å Soap and water
∫ Foam element
4. Check the filter element. If dam-
aged or dirty, replace it.
Y-508
CAUTION
Do not wring out the foam pre-fil-
ter, this could cause it to tear.
5. To replace the elements, reverse
the above steps.
CAUTION
The pre-filter has a notch on one
side. It will only fit in the case one
way.

Drive Belt

To remove the drive belt:
1. Set the drive select lever halfway
between forward and reverse.
2. Pull up on the drive belt and push
it outward over the edge of the
secondary sheave.
3. Turn the secondary sheave clock-
wise and the drive belt will roll off
the sheave.
4. Remove the drive belt from the
Y-60
primary sheave.
G22A