Maintenance And Cleaning - CAN FL1400 Installation, Use And Maintenance Instructions

MAINTENANCE AND CLEANING

No specific maintenance procedures are required for the appliance aside from correct and regular
cleaning.
ATTENTION!
Before cleaning the appliance, make sure that the burner is off.
Always wait for the appliance to completely cool down.
▪
Clean the appliance on a regular basis to keep the materials making up the surface from deteriorating.
▪
Disconnect power (if present) and close the gas supply cocks before any cleaning operation or when
expected to remain idle for a long time. Make sure that all the knobs are always at the "off" position
when finished using the appliance.
▪
Do not use steam appliances or direct water jets to clean the hob unit.
ATTENTION!
Do not use hydrochloric acid (muriatic acid and/or detergents containing chlorides) on the
stainless steel surfaces.
ATTENTION!
Not use abrasive powder detergents which could ruin the appearance of the surface finish.
If some particularly acidic substances (e.g. vinegar, lemon juice, etc.) remain on the appliance for
a long time, they could corrode the surfaces creating unaesthetic rings which however do not
jeopardise operation of the appliance.
type of cleaning
STAINLESS STEEL SURFACES
BURNER SPREADER/CAPS
KNOBS
ATTENTION!
During and after cleaning, check that no nozzle hole is obstructed by impurities or whether
any detergent residues remain at the bottom of the burner cups. If so, remove the impurities
and residues by vacuuming them, without using liquid detergent or similar.
Only for products with steel or chrome-plated iron pan holders: progressive burnishing of the
pan holders is caused by normal use of the appliance and does not jeopardise its performance.
Use a soft cloth slightly soaked in specific neutral detergent or warm
vinegar. Rinse with warm water and dry.
Please note: follow the instructions of their manufacturer to see how to
use the cleaning products).
Remove the components from their housing and wash them with warm
water and dishwashing soap. Stubborn filth on the enamelled components
can be removed using a slightly abrasive sponge and a degreaser, taking
care not to damage the surfaces.
Rinse with warm water and dry. Afterwards put the components back in
place with the utmost attention.
Use a soft cloth slightly soaked in neutral detergent.
Make sure that the detergent does not filter below the knobs.
Do not remove the knobs from the pin they are mounted on.
Please note: follow the instructions of their manufacturer to see how to
use the cleaning products).
Installation, use and maintenance instruction manual
description
▪
Ed. 05/2018 Rev. 00
31