Lighting The Burners - CAN FL1400 Installation, Use And Maintenance Instructions

GAS HOB UNITS COMBINED WITH RECESSED SINK ▪

LIGHTING THE BURNERS

ATTENTION!
Before use, make sure that the burner spreaders, caps and pan holders are positioned properly.
The matching burner is indicated on each knob.
The burner can be lit:
▪
manually using the external igniter (on STD versions),
▪
electronically with 12 V/DC generator (on IGN versions),
▪
piezoelectrically with mechanically/manually operated piezoelectric igniter (on PZ versions).
Proceed as follows to light the burner:
step
1 Press the knob corresponding to the burner you
want to light and turn it anticlockwise (until the
maximum symbol).
2 Simultaneously,
piezoelectric) lighting device with several fast
repeated pulses.
Please note: if the hob unit is not equipped with
these lighting devices, put a portable igniter close
to the burner spreader crown.
3 When lit, keep the knob pressed all the way for
another 5 seconds (at maximum) and then release
it, adjusting the desired intensity of the flame.
Please note: this delay in releasing the knob heats
up the safety thermocouple.
If the burner does not remain lit when you release the knob, it means that the thermocouple was not
preheated sufficiently. To solve this problem, repeat the operations described in the table, keeping the knob
pressed longer after the burner has lit.
ATTENTION!
The burner must be lit without any pan or any other object on the hob unit above the burners.
28
burner spreader positioning
action
activate the electric (or
FL series
1
2