Advertisement
3-4 USE OF DH SWITCH
The DH (Display Hold) switch is for use to
hold the frequency display right before it is
pressed in "ON". In the ON state, the displayed
frequency will not change irrespective of the
mode and operating frequency of the TS-520S.
The TS-520S operating channel can be shifted
to another frequency to check at a glance and
can be immediately returned to the original
channel.
Therefore, the DH feature is avaiable as a sort
of memo.
In the DH mode of operation, the shifted
frequency is to be read on the analog Main
Tuning knob and Sub-dial of the TS-520S.
If used as the frequency counter, your DG-5
also can hold the displayed frequency as long
as necessary with the DH switch in the ON
position.
3-5 AUXILIARY FOOT INSTALLA-
TION
The auxiliary feet, when installed, will
raise the front panel up around 8 mm (3-1/8
inches). To install, refer to Figure 6.
Figure 6. Auxiliary Foot Installation.
9
Advertisement
