Advertisement
FEATURES
1.
Full, Precise Direct Reading of TS-520S
Operating Frequencies As Precise As Order
of 100Hz
Your DG-5 synthesizes all local oscillator
output frequencies, including the hetero-
dyne, VFO, and carrier frequencies, displays
true TS-520S operating frequencies as precise
as an order of 100Hz. It needs no frequency
correction and calibration even when the
band and mode of operation are switched.
2.
Countable up to 40MHz With Single Switch-
ing
Single Switching on the front panel permits
your DG-5 to count frequencies up to
40MHz in units of 100Hz. Thus, it is usefull
as a frequency counter for your shack.
3.
Neat Thin Shape Matching Well With
TS-520S
Your DG-5 is elaborated thinly in the height
to match well with the TS-520S as put on
its top. Thus, it provides comfortable
operation.
4.
Light-Emitting Diode Frequency Display
With Dimmer Switch
Large, light-emitting diodes (LEDs) are easy
to read as your DG-5 is the independent
frequency display and counter. The LEDs
can be halved in the light intensity by
turning the DIM (dimmer) switch to ON.
Also, the LEDs, which are color-masked,
make you free from fatigue for an extended
period of operation, particularly at night.
5.
Simple Connection With TS-520S
Your DG-5 can be easily interconnected
with the TS-520S by plugging the heter-
odyne, VFO, and carrier cables and the
power cord only. These signal cables are
individual to minimize spurious and other
undesirable signal levels.
6.
Available for Use With TS-520
Notice that your DG-5 is tailored specifically
for the new TS-520S. But, if you have the
previous TS-520, you can add a DK-520
Adapter to it for enabling the DG-5 to
be applied to it.
SECTION 1. CHECKING AND CAUTIONS BEFORE USE
This manual was prepared to chiefly describe
how to use your DG-5 Digital Display connection
with the KENWOOD's Model TS-520S SSB
Transceiver.
1
-
1 ACCESSORIES
Carefully unpack your DG-5 and check
that it is supplied with the following accessories.
1. Operating manual
1 copy.
2. Warranty card
1 copy.
(U.S.A.only).
3. Pin plug-equipped signal
1 piece.
cables (red, white, black, gray) each.
4. Counter cable
1 piece.
5. Power cord
1 piece.
6. Auxiliary foot
2 pieces.
7. Screw, auxiliary foot
2 pieces.
1-2 PRECAUTION FOR CONNECTION
WITH TS-520S
Your DG-5 is designed for specific use with
the TS-520S. Before connection, fully under-
stand the operation of the TS-5205 by reading
its operating manual.
1-3 PRECAUTION FOR CONNECTION
WITH TS-520
Your DG-5 cannot be combined with the
TS-520 unless the DK-520 Adapter is used to
provide the TS-520 with connection terminals.
3
Advertisement
