1. Manuals
  2. Brands
  3. Blaze Manuals
  4. Wood stove
  5. B600
  6. Operating instructions manual

Blaze B600 Operating Instructions Manual

Contemporary and stylish range wood heaters
Hide thumbs Also See for B600:
Table of Contents

Advertisement

Quick Links

See also: Instruction and Installation Manual
Pecan Engineering Pty Limited proudly supports the activities of Landcare Australia through its membership of the AHHA

Operating Instructions

Contemporary and Stylish
B600
B900
Keep instructions in a safe place for future reference
DO NOT DISCARD THESE INSTRUCTIONS
B605
B905

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B600 and is the answer not in the manual?

Questions and answers

Related Manuals for Blaze B600

Summary of Contents for Blaze B600

  • Page 1: Operating Instructions

    Operating Instructions Contemporary and Stylish B600 B900 B605 B905 Keep instructions in a safe place for future reference DO NOT DISCARD THESE INSTRUCTIONS Pecan Engineering Pty Limited proudly supports the activities of Landcare Australia through its membership of the AHHA...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS USER INSTRUCTIONS USER INSTRUCTIONS INTRODUCTION …………………………………………… 2 1. INTRODUCTION USING APPLIANCE FOR FIRST TIME ……………… 3 RECOMMENDED FUELS ……………………………….. 3 Before use of this appliance please read these instructions LIGHTING THE FIRE ……………………………………… 3 fully. RUNNING THE APPLIANCE ………………………….. 4 WARNING: ANY MODIFICATION OF THE APPLIANCE THAT BURNING TIPS …………………………………………….

  • Page 3: Using Appliance For First Time

    Plug the lead from the rear of the heater into a power-point.  B600 & B900 models have an override switch on the rear Poor quality timber: panel next to where the power lead exists the heater base. Causes low combustion efficiency This must be switched on for the fan to run.

  • Page 4: Running The Appliance

     Reload with more wood Add larger pieces of wood. Too many logs may smother the fire. 1) Open air slide before opening door.  Close the door. 2) Rake / break up any existing coals.  Do not leave fire unattended while door is not closed. 3) Load the wood with the length orientated front to back.

  • Page 5: Ash Removal

    Factors affecting the flue draught include: 10. CLEANING THE FLUE  Insufficient flue height   Check inside of flue prior to each season for any build- Trees or other buildings nearby causing turbulence up of creosote (wood tar). To do this: ...

  • Page 6: Troubleshooting Tips

    Contact the installer should this happen. B600 & B605 – Brick Layout Trouble starting the fire If all ash has been removed from the firebox, then it can upset the supply of air to the base of the fire.

  • Page 7: Replacement Of Baffle

    3. REMOVING THE DOOR 2. REPLACEMENT OF BAFFLE The 6mm thick steel baffle helps to retain the heat in the To remove the door: firebox by lengthening the path of the flame so that they do 1) Open the door until it rests against the door stop. not go straight up the flue.

  • Page 8: Fitting A New Door Glass

    5. FITTING A NEW DOOR GLASS Glass retainer Door Rope This task may be easier with the door removed from the appliance and laid horizontally on a work-bench. To replace the door glass: Remove the six M6 size Allen key screws securing the glass retainer to the door with the supplied Allen key.

  • Page 9: Changing Fan Controller Frequency

    495mm x 290mm B900 & B905 595mm x 320mm  B600 & B900 Models – located in the base unit, in Door Glass the rear panel on the left hand side, removed via two B600 & B605 483mm x 253mm x 5mm pyro ceramic screws with a M6 Allen key.
  • Page 12 Pecan Engineering Pty Limited 13 Acorn Road, Dry Creek South Australia 5094 T: (08) 8349 8332 | F: (08) 8260 6643 Email info@pecan-eng.com.au...

This manual is also suitable for:

B900B605B905

Table of Contents