Toshiba RAV-RM301KRTP-E Installation Manual page 38

6
If there is other indoor unit to be changed,
repeat procedure
setup.
When the above setup has finished, push
to select the indoor UNIT No. before
change of setup, specify CODE No. [12], [13],
[14] in order with TEMP.
and then check the changed contents.
Address change check Before change:
[3-3-1] → After change: [2-2-2]
Pushing button clears the contents of
which setup was changed.
(In this case, procedure from
Indoor UNIT No. before setup change is displayed.
7
After check of the changed contents, push
button. (setup is determined.) When
button is pushed, the display disappears
and the status becomes the usual stop
status. (when
operation from the remote controller is not
accepted for approx. 1 minute.)
* If the operation from the remote controller is
not accepted even 1 minute or more passed
after pushing
the address setup is incorrect.
In this case, the automatic address must be
again set up.
Therefore repeat procedure of the setup
change from the Procedure
37-EN
2 5
to to change the
/ buttons,
2
is repeated.)
button is pushed the
button, it is considered that
1
.
To recognize the position of the
corresponding indoor unit though the
indoor UNIT No. is known
Check the position during operation stop.
(Stop operation of the set.)
1, 3
1
Push +
for 4 seconds or more.
After a while, the display part flashes and
the display appears as shown below.
In this time, the position can be checked
because fan of the indoor unit operate.
• For the group control, the indoor UNIT No.
is displayed as [
indoor units in the group control operate.
Check the displayed CODE No. is [01].
• When the CODE No. is other than [01],
push button to erase the display and
repeat procedure from the first step.
(After pushing
the remote controller is not accepted for
approx. 1 minute.)
(* Display changes according to
the model No. of indoor unit.)
2
In the group control, every time
button is pushed, the indoor UNIT No. in
the group control is displayed in order.
In this time, the position of the indoor unit can
be confirmed because only fan of the selected
indoor unit operate.
(For a group control, No. of the firstly
displayed indoor unit becomes the header
unit.)
3
After confirmation, push
return the mode to the usual mode.
When button is pushed, the display
disappears and the status becomes the usual
stop status.
(When button is pushed the operation
from the remote controller is not accepted for
approx. 1 minute.)
‒ 37 ‒
Installation Manual
1
2
buttons simultaneously
] and fans of all the
button, operation of
button to