Toshiba RAV-RM301KRTP-E Installation Manual page 37

[Procedure example]
Manual address setup procedure
While the operation stops, change the setup.
(Stop the operation of the unit.)
3
-2,
4
-2,
5
-2
7
1
1
Push + +
for 4 seconds or more. After a while, the
display part flashes as shown below.
Check the displayed CODE No. is [10].
• When the CODE No. is other than [10],
push button to erase the display and
repeat procedure from the first step.
(After pushing
the remote controller is not accepted for
approx. 1 minute.)
(For a group control, No. of the firstly
displayed indoor unit becomes the header
unit.)
(* Display changes according to
the model No. of indoor unit.)
2
Every time
indoor UNIT No. in the group control is
displayed in order. Select the indoor unit
of which setup is changed.
In this time, the position of the indoor unit of
which setup is changed can be confirmed
because fan of the selected indoor unit
operate.
3
1) Specify CODE No. [12] with TEMP.
/ buttons.
(CODE No. [12]: Line address)
2) Change the line address from [3] to [2]
with TIME /
7
3
-1,
4
-1,
5
-1,
6
3
-3,
4
-3,
5
- 3
2, 6
buttons simultaneously
button, operation of
button is pushed, the
buttons.
3) Push button.
In this time, the setup finishes when
the display changes from flashing to
lighting.
Indoor unit No. before setup change is displayed.
4
1) Specify CODE No. [13] with TEMP.
/ buttons.
(CODE No. [13]: Indoor address)
2) Change the indoor address from [3] to
[2] TIME
3) Push button.
In this time, the setup finishes when
the display changes from flashing to
lighting.
Indoor unit No. before setup change is displayed.
5
1) Specify CODE No. [14] TEMP.
buttons.
(CODE No. [14]: Group address)
2) Change the SET DATA from [0001] to
[0002] TIME
(SET DATA [Header unit: 0001] [Follower
unit: 0002])
3) Push button.
In this time, the setup finishes when
the display changes from flashing to
lighting.
Indoor UNIT No. before setup change is displayed.
‒ 36 ‒
Installation Manual
/ buttons.
/ buttons.
/
36-EN