Thanks ter, especially cold water, such as in Spring, Fall, and Winter, which poses a hazard in We at Kasco Marine, Inc. would like to both and of itself. thank and congratulate you on your purchase • NEVER lift or drag the fountain by the of the 1400JF Aerating Fountain.
We WARRANTY strive to produce products that exceed cus- Kasco Fountains are the result of over 35 years tomer expectations. We hope you enjoy your of design and engineering. Kasco products Kasco Fountain.
Page 4
Inspect the shipment Installed) (5) for any damages. If damages are found, im- mediately notify your carrier and your Kasco Marine, Inc. representative. Next, cross refer- ence the parts included in the shipment with Falcon #3...
Page 5
STEP THREE 1/4 –20 x 7/8” Locate the 5 nozzles included with the ship- Fillister Head ment (the Osprey nozzle is already installed Screw Eagle’s Nest Nozzle on the fountain, along with the Upper Pump Housing). Using the Nozzle Options diagram on page 7, determine which pattern is desired and the corresponding nozzle.
Page 6
STEP SIX Use the ropes to position the Fountain in the desired location in the pond/lake. Anchor the ropes or secure them to the shoreline so the ropes are free of slack, but not tight. To pre- vent twisting of the unit due to torque, you should place the anchor at least 3 feet from the loat for each foot of depth (Ex.
Comes installed on unit. ment on and every 30 days thereafter. Plug the 1400JF cord into the C-25 outlet labeled Condor: “UNIT”. If lights are included, plug the Transformer cord into the C-25 outlet labeled “LIGHT”.
CIAN! nozzle attached to the upper pump housing to help you pull the up- Failure to use the C-25 with Kasco Fountains per pump housing out of the fountain tube will void the warranty and cause the Fountain for cleaning or nozzle changes.
Kasco Marine at 715-262-4488 for C-25 Control Box will turn the aerator/foun- further instructions or email Kasco at ser- tain ON & OFF with the TIMER. Kasco lights vice@kascomarine.com. will turn ON with the PHOTO EYE and OFF with TIMER.
(can). The motor housing date of shipment. Customer shall pay shipping is the surface that dissipates heat into the wa- charges for returning the unit to Kasco or an ter and any algae, calcium, etc. build-up will Authorized Repair Center.
Page 11
Fountain online at: Any expedited shipping method for the return www.kascomarine.com of the unit is at the customer’s expense. Kasco Marine will return units repaired under war- Once the warranty coverage has been estab- ranty at our expense via ground freight within lished, the unit may be sent to any Kasco the continental United States.
All estimates that are rejected for repair will be destroyed unless otherwise directed by the you contact Kasco to narrow down the prob- customer. If the customer would like the unit lem.
Page 13
If something is caught in the unit or there is a build-up on the unit, remove the debris and, if caught early enough, the unit should be ine. Contact a Kasco representative before restarting the unit. “My Fountain low seems to luctuate and/or be less than usual.”...
Replacement Parts Diagram 1400JF/1400JFL Replacement Parts ITEM NO. PART NO. DESCRIPTION COMMENTS 140012 FLOAT, 1400 SERIES AVAILABLE ON 140412 LIGHT RING ASSEMBLY 1400JFL ONLY 140112 PUMP HOUSING, LOWER 140312 RETAINING CLIP 140512 UPPER PUMP HOUSING 140910 CAN, 1400 SERIES AVAILABLE ON 258476 FLAT WASHER, 1/4"...
3 years depending on use. • Address your Repair to Kasco Marine, Attn: Repairs (or to your Authorized Repair Center). • Shipping to Kasco or an Authorized Repair Center is paid for by the customer.
Registration Information Please register your fountain online at: www.kascomarine.com Also ill in the information below and keep for your records. Model # (Ex. 1400JF)_______________________________ Serial # (Ex. 7001J141725)______________________________ Purchase Date:_____________________ Purchased From:___________________________________ Registration Date: ___________________________ Kasco Marine, Inc. 800 Deere Rd.