Restarting The Air Conditioning Unit In The Case Of Breakdown; Regular Maintenance Activities For Which The User Is Responsible; Maintenance Schedule - York VCH 20A User Manual

1 User manual
1.8

Regular maintenance activities for which the user is responsible

N O T E
• The fault pilot light on the DPC-1 thermostat display will flash if a fault code between 0 and 90 is
shown.
• The fault pilot light on the DPC-1 thermostat display will also flash if fault code 93 is shown.

1.7.5 Restarting the air conditioning unit in the case of breakdown

Where the unit is to be restarted, press the MODE
-1- button on the thermostat repeatedly until OFF -2-
is displayed on the screen.
Then, restart the unit by pressing the MODE button
and selecting the required operating mode.
The unit will start up normally if the cause of the fault
is no longer present. If the cause persists, it is possible
to start the unit a maximum of three times within a 24-
hour period.
Where the thermostat screen continues to display the
indicator -1- and any fault code -2- or if the air
conditioner does not start, contact a Johnson Controls
Inc. Authorised Technical Assistance Service.
1.8 Regular maintenance activities for which the user is
responsible

1.8.1 Maintenance Schedule

The HVAC unit is designed to require as little maintenance as possible. Nevertheless, to ensure the
correct operation of the unit with a minimal use of electricity, a long working life and compliance with the
regulations of each country, regular maintenance inspections must be made.
Johnson Controls Inc. shall not be considered responsible for any damage caused by improper
maintenance of the HVAC unit, which includes anything inconsistent with that described in this document
or others specifically provided with the unit.
12
2
OFF
ºC
3
PROG MODE
1
AUTO
AUTO
2
1
ºC