Installing The Cnc Piranha Fx/Xl Post Processors In Vectric Products - Next Wave Automation CNC PIRANHA XL Owner's Manual

There is no requirement to run VCarve on the same computer as you use in the shop to connect
to the Piranha FX/XL Controller Interface.

Installing the CNC Piranha FX/XL Post Processors in Vectric Products

Vectric's VCarve, Vcarve and Aspire should have the CNC Piranha FX/XL post processors
installed. However, Next Wave Automation periodically updates these, and you may want to
install the latest CNC Piranha FX/XL post processors. Additionally, older Vectric products may
not have the CNC Piranha FX/XL post processors installed so using the CNC Shark one will work
as well.
Currently, there are 2 sets of post processor files:
• One set is used with VCarve, Cut 3D, and Aspire
• One set is unique and used only with Photo VCarve
You can update the post processor used by any Vectric product by downloading the latest
version from the Downloads page and copying it to the Vectric product's post processor folder.
The folder locations for each Vectric application are discussed below. In no case should you
attempt to download the post processor file directly from the Downloads page to the final
destination folder. You should copy the post processor file(s) to a known location – typically
somewhere in /My Documents – and then copy that file to its final destination.
FOR THE MOST RECENT MANUALS, DRIVERS, AND OTHER SOFTWARE, PLEASE VISIT THE
April 2018
DOWNLOAD TAB AT
http://nextwaveautomation.com
CNC Piranha FX/XL | 22