Operating Your Cnc Piranha Fx/Xl - Using The Pendant; Machining The Part - Next Wave Automation CNC PIRANHA XL Owner's Manual

Operating your CNC Piranha FX/XL - Using the Pendant

Machining the Part

The material to be machined is placed on the Piranha FX/XL work table and properly secured –
typically by using clamps. The proper cutter tool is placed in the router. Using the Piranha
FX/XL LCD Pendant Touch Screen, the tool is moved (jogged) to correspond with the starting
point of what you have designed, usually a corner or center of the work piece. Once you have it
in position you press the Zero xyz button, answer yes to reset zero and this becomes the
starting and stopping place for this project. (You can place your material anywhere on the table
and reset home in this manner)
Toggle any of the 3 Axis
Set new Zero Home
here
You can also move any axis by typing a measurement directly into the current location screen.
Pressing the location area will display the screen below.
Enter the desired
location using the
numeric keypad
April 2018
Main Screen of CNC Piranha FX/XL
Control Speed of
Toggle Movement
Then press the
Move Button
CNC Piranha FX/XL | 15