Advertisement
S e r v e R A I D - M R 1 0 k S A S / S A T A D I M M
I N S T A L L A T I O N
Attention: Back up your data before you change your
system configuration. Otherwise, you might lose
data.
Figure 3
shows the installation of the ServeRAID-MR10k
SAS/SATA Customized Enabler DIMM.
Figure 3 Installation of the ServeRAID-MR10k
SAS/SATA DIMM
iTBBU
Cable
guide
Battery
cable
connector
RAID
DIMM
Perform the following steps to install the ServeRAID-MR10k
SAS/SATA Customized Enabler DIMM.
Step 1
Read the safety information that begins in the
preface and the installation guidelines in this
section.
Step 2
Turn off the server and peripheral devices, and
disconnect the power cords and all external
cables as necessary to replace the device.
Important: When handling static-sensitive devices, take
precautions to avoid damage from static
electricity.
Step 3
Remove the server cover.
Step 4
Remove the divider that contains the battery
holder from the server.
Step 5
Open the retaining clip on each end of the
connector.
Step 6
Touch the static-protective package that contains
the DIMM to any unpainted metal surface on the
outside of the server; then, remove the DIMM
from the package.
Step 7
Turn the DIMM so that the keys align correctly
with the slot.
Step 8
Insert the DIMM into the connector by aligning
the edges of the DIMM with the slots at the ends
of the connector.
Important: Incomplete insertion might cause damage to the
server or the DIMM.
Step 9
Firmly press the DIMM straight down into the
connector by applying pressure on both ends
simultaneously.
Battery
cable
The retaining clips snap into the locked position
when the DIMM is seated in the connector.
Cable
Step 10
Install the iTBBU in the divider that contains the
guide
battery holder.
Step 11
Install the divider that contains the iTBBU holder
in the server.
Step 12
Route the iTBBU cable through the cable routing
guides on the divider to the DIMM.
Step 13
Insert the battery pack harness at the end of the
cable into the J1 connector on the backside of the
DIMM.
The installed ServeRAID-MR10k SAS/SATA
Customized Enabler DIMM is shown in
Figure 4 ServeRAID-MR10k Installed in a System
Edge of
Motherboard
Step 14
Reinstall the server cover and reconnect the
power cords.
2 of 3
Figure
4.
Edge of
Motherboard
85023-05
Advertisement
