Sleep Tracking - Mio FUSE User Manual

Scroll: Tap the scroll touchpoints to scroll through workout metrics.
Pause: Touch and hold the heart rate/timer touchpoint A to pause the timer. Tap it again to resume.
End Workout: Pause your workout (see above), then touch and hold the heart rate/timer touchpoint A to
end your workout.
If you see -- displayed, press and hold touchpoint A to stop heart rate mode, check watch placement is
correct and start over.

6. Sleep Tracking

6. Sleep Tracking
Your FUSE must have firmware version 1.20 or higher to enable sleep tracking. Check
your FUSE firmware version in Mio GO, at the bottom of the device's Setup screen. If your firmware needs
updating, follow these instructions for iPhone/IOSandinstructions for Android.
In sleep mode, FUSE tracks your sleep duration, resting heart rate, level of sleep (awake/light/deep), and
sleep efficiency.
Activate Sleep Mode
Touch and hold both Scroll Touchpoints until the display changes from "HOLD" to "SLEEP?".
Tap the Heart Rate/Timer Touchpoint to confirm that you want to go to sleep. FUSE will display a good
night message.
The display will show "ZZZ" any time you touch a Touchpoint while your FUSE is in Sleep Mode.