Advertisement
Screw the four attached metal distant spacers with the four attached nuts on the other holes of the
Style-EX Board.
Connect the HD-Cable from the PSR-8000 to the free 44Pin connector on the STYLE-EX board. The
red pin (number 1) should be placed in the near of the capacitor. (see picture)
Screw all on the metal cover and then all to the PSR-8000.
3. Initialising and test
3.1 Initialising
After the installation a Initialisation is necessary.
Make the following steps:
1. Press the Cis 2, F 2 und Gis 2 on the Keyboard and while pressing this keys switch the PSR-8000
on. The test menu appears.
2. Press the right Tempo switch again and again until 047: Factory Set is displayed.
3. Press START/STOP switch.
4. Afterwards switch the PSR-8000 off and on – the keyboard is initialised now.
3.2 Test
If you switch the keyboard on and the message
Replace style-expansion battery!
!
Save all data on disk before
replacing battery
appears, so you should exchange in the next 2-3 weeks the backup battery of the Style expansion.
The battery is soldered directly on the board of the Style Expansion that is mounted in the hard disk
recess.
We strongly recommend to make a complete data backup on floppy disk or hard disk before you
exchange the battery.
No function of the style-expansion !
!
Check the installation
of the Style-Expansion
The is probably an error in the installation of the style expansion. Check the installation of the Style
expansion (refer to the installation manual). For secure a switching of the style banks is impossible.
It is not possible to change Style banks:
First check if you are in the Groove Style or Custom Style Edit Menu. Press EXIT to leave these
Menu..
If you still have problems please check the installation (see installation manual).
After changing the backup battery it could be necessary to make a complete initialisation of the
PSR-8000 keyboard.
Advertisement
