Furuno GP-1871F Operator's Manual page 19

1. SYSTEM INTRODUCTION
• [Slide Show From SD]: Displays images (photos) stored on the inserted SD
card as a slide show.
• [Simulation]: Activates the simulation mode and allows you set parameters for
the simulation.
4. Tap the [<] icon at the top-left of the selection window to go back to the [Simula-
tion] menu.
5. If you selected [Internal Slide Show] or [Slide Show From SD], the slide show
starts. To stop the slide show, tap anywhere on the screen, then tap [Yes] in the
pop up window, then proceed to step 9.
If you selected [Simulation], proceed to step 6.
6. In the [Parameters] section, set the [Course] and [Speed] for the simulation.
To set these items, either drag the slider bar or tap the keyboard icon to manually
enter a value.
7. To set [Date] and [Time], tap the item in the menu to show the software keyboard.
Enter the desired date/time for the simulation, then tap the [<] icon to go back to
the simulation settings.
8. At [Fish Finder], tap the desired setting for the simulation, then tap the [<] icon to
go back to the simulation settings.
• [Off]: no fish finder data is simulated.
• [Chirp Demo]: Show the CHIRP simulation.
• [RezBoost Demo]: Show the RezBoost simulation.
Note: The fish finder simulation operates separately from other settings in the
[Simulation] menu. To disable the fish finder simulation, change the above setting
to [Off].
9. Tap the [ ] icon at the top-right corner of the menu to close the menu.
1-10