Installation Connections - Coda S150 Operation Manual

INSTALLATION CONNECTIONS

The first section of the installation instructions for the AMPLIFIER SYSTEM is a diagram of
the default configuration required to bring the amplifier into an operating mode. These brief
steps will allow you to begin operating your system. Make sure during installation that the
main AC power switch on the back of the CURRENT AMPLIFIER S150/250 is turned off, and
AC power connection to the VOLTAGE AMPLIFIER SV is interrupted. While the diagram may
be self explanatory, we strongly recommend that you read the detailed instructions following
this introductory section.
Note: 1. You may attach both XLR and RCA inputs to the SV at the same time.
2. Use only the supplied interconnect cables between the SV and the S150/250.
~
! AC LINE INPUT FOR CONTIMUED PROTECTION AGAINST
SEE SERIAL T AG FOR SHOCK OR FIRE HAZARD, DO NOT EXPOSE
POWER REQUIREMENTS THIS UNIT TO RAIN OR MOISTURE.
LEFT SPEAKER
OUTPUT TO CODA CURRENT AMPS ONL Y
LEFT RIGHT LEFT
LEFT
RIGHT
INPUT FROM SYSTEM VOLTAGE AMP ONLY
RIGHT LEFT/BRIDGED
PARALLEL SPLIT
USE ONLY SPECIFIED FUSE TYPE
6
120
8
BALANCED INPUT UNBALANCED INPUT
RIGHT LEFT RIGHT
3
PREAMPLIFIER
PREAMPLIFIER
RIGHT SPEAKER