Secondary Function (Shift): Activating Loops; Fine Loop Adjustments - Native Instruments TRAKTOR KONTROL X1 Manual

LOOP Knob – Turn
▪ Turning the LOOP knob while no loop is active will change the currently selected loop
length.
▪ Turning the LOOP knob while a loop is active will change the length of the active loop
by moving its end point.
LOOP IN Button (labeled IN)
▪ Pressing LOOP IN will set a manual Loop In point. The LOOP IN button will light, in-
dicating that TRAKTOR is waiting for a Loop Out point.
▪ Pressing LOOP IN again without setting a Loop Out point will exit manual Loop set-
ting and the LOOP IN light will turn off.
LOOP OUT Button (labeled OUT)
▪ When pressed alone, LOOP OUT will automatically set a 4 bar loop.
▪ When pressed after LOOP IN, LOOP OUT will set a manual Loop Out point.
Pressing the LOOP knob while a loop is active will always deactivate any manual or Auto
loop.
4.3.2

Secondary Function (SHIFT): Activating Loops

LOOP Knob – Push
▪ Holding SHIFT and pushing the LOOP knob will cause TRAKTOR to loop the next
stored Loop point it comes across in that track.
LOOP Knob – Turn
▪ Holding SHIFT and turning the LOOP knob will move the entire loop by 1 beat steps
left or right.
4.3.3

FINE LOOP Adjustments

▪ To move a Loop in non-quantized steps, hold the LOOP IN button and turn the LOOP
knob.
▪ To move a Loop Out point in non-quantized steps, hold the LOOP OUT button and
turn the LOOP knob.
Using the TRAKTOR KONTROL X1 with TRAKTOR PRO 2
TRAKTOR KONTROL X1 - Manual - 17
LOOP Section