Installation check and warnings IMPORTANT: Please ensure that the oven cavity, venting and wiring is as specified in the relevant section H of this manual. It is important to the performance of the oven to allow sufficient air circulation around the appliance. All installation, adjustments and maintenance operations must be carried out by qualified technicians in accordance with the enclosed instructions and current installation standards.
Installation instructions. INFORMATION FOR THE INSTALLER THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN. WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS. DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN WARNING: Installation must comply with Standards North America (within North America) wiring rules, as well as your local electrical and building codes and regulations and any other applicable requirements.
SEO 60 - Single Oven Measurements VOID (Cut-out) Cut-out:...
SEO 76 - Single Oven Measurements VOID (Cut-out) Cut-out:...
SEO 90 - Single Oven Measurements Cut-out: VOID (Cut-out)
It is important to the performance of the oven and the protection of adjoining cabinets that the following installation preparation is observed. 1. The oven cavity floor should accommodate an opening to allow a satisfactory flow of air to circulate around the appliance. Should the oven be placed under counter, below an AEG cooktop, be it either gas or electric, it is acceptable as long as the base of the cabinet that the oven sits on, has the centre piece of wood, as per the installation instructions, removed. The oven requires a source of fresh air preferably from below, a minimum opening of 100 sq. in or 645 sq. cm will be sufficient. If the ...
I - Electrical wiring diagrams and instructions WARNING: All aspects of the installation must conform with the requirements of the standard North America (within North America) wiring rules, as well as your local electrical and building codes and regulations, and any other applicable requirements and conditions of your local power supply authority.