Switching The Pedal's Polarity (Control Pedal Polarity); Using Program Change Messages To Switch Setups (Setup Control Channel); Using The Pedal To Switch Setup (Setup Pedal Shift); Making The Settings For The Usb Driver - Roland RD-300SX Owner's Manual

Switching the Pedal's Polarity
(Control Pedal Polarity)
This switches the polarity of the pedal connected to the PEDAL
(CONTROL) jack on the rear panel.
On some pedals, the electrical signal output by the pedal when it is
pressed or released is the opposite of other pedals. If your pedal has
an effect opposite of what you expect, set this parameter to REVERSE.
If you are using a Roland pedal (that has no polarity switch), set this
parameter to STANDARD.
Indication Value
STANDARD
REVERSE
Using Program Change Messages
to Switch Setups
(Setup Control Channel)
You can switch the RD-300SX's Setups with MIDI messages from an
external MIDI device.
Set the MIDI Receive channel for receiving the MIDI messages
(Program Changes) from the external MIDI device to be used for
switching Setups.
When not switching Setups from an external MIDI device, set this to
OFF.
Value
1–16, OFF
When the Control Channel settings are transmitted along with
the part's MIDI receive channel, switching of Setups takes
priority over the switching of tones. For more on program
changes for switching Setups, refer to "Switching Setups" (p.
49).
Settings for Each Function ([EDIT])
Using the Pedal to Switch Setup
(Setup Pedal Shift)
You can use the pedal which is connected to the PEDAL (CONTROL)
jack on the rear panel as a dedicated switch for selecting Setup in
order.
Indication Value
OFF
ON
The function set with Control Pedal Function (p. 40) cannot be
used when this is switched to ON.
Making the Settings for the USB
Driver
If you intend to connect to a computer using the USB connector, you
need to make the following setting before you make the connection.
After changing settings, turn the power off and then on again.
There is no need to use the Write procedure for the USB Driver
settings.
Indication Value
Original
Generic
Description
You can use the pedal function
set with Control Pedal Func-
tion (p. 40).
This becomes a dedicated
switch for switching Setups.
Description
Select this when using the supplied
driver with a USB connection.
Select this when using a gener-
ic USB driver included with the
OS with a USB connection.
39