Advertisement
SHORT OPERATIONS MANUAL
Manufacturer:- TESTO
1.
INTRODUCTION
The Testo 171, 175 & 177 series of data loggers are
precision instruments designed to measure and record
various parameters including temperature / relative humidity.
Parameters measured are dependant upon model.
following short form instruction manual covers the basic
operational aspects of the above instruments, for a full instruction manual please contact us.
2.
CHOOSING THE LOCATION FOR YOUR INSTRUMENT (IMPORTANT PLEASE READ)
For ambient temperature / relative humidity models the instrument should be sited at a location that is
typical of the ambient conditions and is not affected by any external temperature / humidity sources.
Avoid placing the instrument in or near the following locations:- . Bright sunlight, Air conditioning
inlets & outlets, radiators, computers / monitors or other office equipment (that may give off heat), damp
corners, by fans or sinks and any draughts in general. Also avoid handling the instrument as this may
also affect its readings.
THE INSTRUMENT SHOULD BE KEPT DRY AT ALL TIMES.
For ambient condition monitor logger models, the instrument will take approximately 30min to 1 hour to
acclimatise.
3.
LOGGER IDENTIFICATION (IMPORTANT PLEASE READ)
When returning your rental logger please ensure you keep record of where the loggers have been placed.
BSRIA Instrument Solutions rental instruments are identified by two sets of numbers, a group code and a
unique six digit ID e.g. 200123 it is recommended that you use this 6 digit ID code to identify the
instruments location.
Please do not affix any other labels to our instruments.
4.
CONFIGURING THE INSTRUMENT
Sections 5 & 6 deal with the various set up options i.e. starting modes, Stopping modes, logging intervals
etc available. These configurations can only be changed using the optional software. BSRIA Instrument
Solutions can pre configure the instrument to the customers requirements prior to the start of the hire at no
extra cost.
Unless otherwise requested by the customer the DEFAULT setup for the instrument is as shown below:-
SAMPLE RATE =
START MODE =
STOP MODE
Whilst every effort has been made to ensure the accuracy of the information given in this short manual, no liability is given or implied for any error or
omission contained herein. Due to our policy of improvement, Instrument Solutions reserve the right to change products and/or services without notice.
Date :- 09 January 2009
5mins,
"KEYPAD" for 177 & 175's and "MAGNETIC" start for 171's .
=
Until memory is full
BSRIA Instrument Solutions
Old Bracknell Lane West,
Bracknell,
Berkshire,
RG12 7AH
Tel: +44 (0) 1344 459314
Fax: +44 (0) 1344 465556
E mail :
info@bis.fm
Model : 171, 175 & 177 Series
The
171-3
Testo 175-H2 177-T2 171-3 short user manual.doc
175-H2
175-S1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TESTO 171-3
Summary of Contents for TESTO 171-3
- Page 1 Manufacturer:- TESTO Model : 171, 175 & 177 Series INTRODUCTION The Testo 171, 175 & 177 series of data loggers are precision instruments designed to measure and record various parameters including temperature / relative humidity. Parameters measured are dependant upon model.
- Page 2 The logger can be configured (using software) to stop by either of the following ways, UNTIL MEMORY IS FULL, NUMBER OF LOGS, WRAP AROUND MEMORY, DATE / TIME. Once stopped the logger can only be restarted using software or the optional Testo 580 Data Stick or a Test575 printer (only applicable for 175/177 models only).
Need help?
Do you have a question about the 171-3 and is the answer not in the manual?
Questions and answers