Page 3
The instrument application modules contain a single nonvolatile EEPROM which holds application module code. No user data is stored in the application modules. If you have any questions, contact the Tektronix Technical Support Center at http://www.tektronix.com/support Memory Erasure A USB host port is standard on TDS3000C models. Remove all USB flash drives.
Page 4
5. Clear all settings. If you need to restore network connectivity at a later date, make sure to write down all setting values before clearing them. 6. Push the OK Accept side bezel button. The LAN system is disabled and no longer allows data traffic in or out. TDS3000C Series Declassification and Security Instructions...
Page 5
The memory parts used in the TDS3012C, TDS3012C-NV, TDS3014C, TDS3032C, TDS3032C-AF, TDS3034C, TDS3052C, and TDS3054C oscilloscopes are shown in the following table. Table 1: TDS3000C series memory parts, board numbers 679- 0259- XX and 679- 0263- XX Reference Part number...
Page 6
Table 2: Application module memory part, board number 679- 4489- XX Reference designator Part number Description 156- - 6272- - XX IC, MEMORY; CMOS, EEPROM; 256 X 8, SERIAL EEPROM: holds the application module code. TDS3000C Series Declassification and Security Instructions...