Table of Contents
Advertisement
saved when the stand-by power fails during the
stand-by mode. In this case, LED warning indication
will appear, so check the error data by the warning
status.)
(3) Warning dialog window
1. The warning dialog window displays the error location.
2. "ERROR TIME (SET TIME)" displays the time when the
warning history data has been saved (the SET TIME in
the service menu). "ERROR TIME" and "SET TIME"
shown in the main dialog window are useful to know
when the error occurred.
3. Pressing the Detail button activates the Notepad and
opens the file containing the information about the set
and the warning data. To prevent writing over this file,
be sure to select "Save As" from "File" of the menu in
the Notepad to save the file. The name of the file being
displayed should be "DataTemp.txt".
4. Pressing the Warning Clear button displays the
confirmation message window, which asks you whether
you will clear the warning history data. Press the OK
button to clear the warning history data or the Cancel
Indicates which data of the
Warning Status, Warning History
1, 2, or 3 are displayed.
All the error items are
displayed in red and their
check boxes are checked.
button to cancel clearing them.
5. Pressing the Back button displays the main dialog
window again and carries out communication with the
projector again to get information from it.
(4) Switching the COM port
1. Select the serial port to which the cable is being
connected. When the selected serial port isn't available
or doesn't exist, an error message window is displayed.
2. Press the OK button to switch the COM port. When the
serial port is switched correctly, communication with the
projector is carried out again to get information from it.
Displays the SET TIME
when the warning history
data were saved.
Creates a
Clears all the
detailed report.
warning history data.
Warning dialog window
- 4 -
COM port switching dialog window
Goes back to the
main dialog window.
Advertisement
Table of Contents
