3. Removal of PREAMP PCB ASSY and
LAMP POWER UNIT
1. Remove the Top Case Assy and the Terminal Board
following "1.Removal of TOP CASE ASSY and
SPEAKER". (Fig. 3-1)
2. Remove the two (a) screws and take out the Lamp
Power Assy.
3. Release the (b) hook and remove the PREAMP PCB
ASSY as shown in Fig. 3-3.
Note: Also disconnect the AL connector on the PREAMP
PCB ASSY when removing the PREAMP PCB ASSY.
4. Disconnect the A and the B connectors on the Thermal
Protector as shown in Fig. 3-3.
5. Remove the two (c) screws and the Lamp Power
Connector as shown in Fig. 3-3.
6. Release the (d) hook and remove the LAMP POWER
UNIT as shown in Fig. 3-3.
Note: Also disconnect the CN1 and the CN2 connectors
when removing the LAMP POWER UNIT.
4. Removal of TERMINAL ASSY
(MAIN PCB ASSY, INLET PCB ASSY,
TERMINAL PCB ASSY )
1. Remove the Top Case Assy and the Terminal Board
following "1.Removal of TOP CASE ASSY and
SPEAKER". (Fig. 3-1)
2. Release the (a) hook and remove the Filter Cover as
shown in Fig. 3-4.
3. Remove the four (b) screws, the (c) screw, the (d)
screw and the three (e) screws as shown in Fig. 3-4.
4. Disconnect the fifteen connectors (SA, SD, SF, SJ, SL,
SN, SP, SV, SW, SX, SY, SZ, SBX, SGX and SRX) on
the MAIN PCB ASSY as shown in Fig. 3-4.
5. Open the Power Barrier slightly and disconnect the RE
connector on the POWER PCB ASSY and the A and the
B connectors on the Thermal Protector as shown in Fig.
3-4.
6. Remove the Terminal Assy (MAIN PCB ASSY, INLET
PCB ASSY and TERMINAL PCB ASSY) as shown in
Fig. 3-4.
Note: Also remove the (f) screw of the Power Assy and
the earth wire from the Terminal Shield.
c x2
LAMP POWER UNIT
Lamp Power
Connector
CN1
A
d x1
SN
SY
SJ
SV
(MAIN PCB ASSY
SX
INLET PCB ASSY
TERMIAL PCB ASSY)
Terminal Assy
earth wire from
Terminal Shield
A
Filter Cover
- 10 -
a x2
PREAMP
PCB ASSY
d x1
AL
b x1
CN2
B
Fig. 3-3
c x1
SF
SL
b x1
SZ
SP
SGX
SW
SA
SRX
SBX
f x1
RE
B
b x3
a x1
Fig. 3-4
e x3
SD
Power
Barrier