Functions - Breville the Scraper Beater LEM250 Instruction Book

Functions

OPERATING THE MIXER
1. Ensure the speed control dial is set to the
OFF position.
2. Using the tilt release lever, open the mixer
head into a diagonal position and lock into
place.
3. Secure the mixing bowl into place on the
mixer base.
4. Attach the required attachment for your
mixing task and attach the pouring shield, if
required.
5. Place all ingredients in the mixing bowl as
listed in the recipe.
6. Using the tilt release lever, close the mixer
head and lock into place.
NOTE
Always ensure the tilt release lever is held
down when changing the position of the mixer
head. Release the lever to lock the mixer head
into position.
7. Insert the power cord into a 230 or 240V
power outlet and switch the power outlet on.
8. Commence mixing by turning the speed
control dial in a clockwise direction to
the setting outlined in the recipe. It is
recommended to start any mixing task on
a lower speed to prevent splattering, then
increase the speed as required.
NOTE
The speed control dial may need to be turned
slightly past KNEADING for the mixer to
commence mixing.
12
LEM250_BW_IB_B16.indd 12
WARNING
Never exceed speed setting KNEADING when
working with heavy ingredients such as dough.
9. If required, occasionally stop the mixer
during operation and scrape any mixture on
the sides of the mixing bowl with a spatula.
NOTE
Always turn the speed control dial to the OFF
position if you need to scrape down the mixing
bowl during use. Then recommence mixing.
10. When mixing is complete, turn the speed
control dial to the OFF position, switch the
mixer off at the power point and remove the
power cord from the outlet.
11. Remove the mixing bowl and mixing
attachment from the mixer body.
WARNING
After mixing, remove the attachment with care
as it may be hot after use.
OVERLOAD PROTECTION SYSTEM
The motor in this mixer is protected from
burning out by a manual reset cut-out
switch. If the mixer is overloaded or operated
continuously for too long, the motor may
overheat and stop. To operate the mixer
again, turn the speed control dial back to
OFF, turn the mixer off and unplug it from
the power point. Allow the mixer to cool for
approximately 30 minutes. Once the motor is
fully cooled, it is ready for use again.
Do not operate the mixer continuously with
an excessive load for more than 3 minutes. To
reduce the risk of overloading, remove some of
the mixture and process in smaller batches.
26/10/2016 1:01 pm