Sleep Timer Function / Setting The Clock - LG MCV902 Owner's Manual

Selecting the sound system
(MCV902 model)
You can enjoy different sounds by selecting the
sound mode you want.
Press LINK on the remote control repeatedly to
select the sound mode.
LINK ON → SURROUND 1 → SURROUND 2
Using the subwoofer
(MCV902 model)
You can use the sound of the subwoofer to
enhance the bass.
Press WOOFER POWER on the remote control
repeatedly (or press POWER on the subwoofer)
to turn on the subwoofer.
SUB_WOOFER ON ↔ SUB_WOOFER OFF
Using Microphone - OPTIONAL
You can sing to a music source by connecting a
microphone to the unit.
1. Connect your microphone (not supplied) to the
MIC jack.
" " will be shown in the display window.
2. Play a music you want.
3. Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOLUME KNOB.
Notes:
• When not using the microphone, set the MIC
volume knob to minimum or turn off the MIC
and remove the microphone from the MIC jack.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case,
move the microphone away from the speaker
or decrease the sound level by using the MIC
volume control.
• If sound through the microphone is extremely
loud, it may be distorted. In this case, turn the
MIC volume control toward minimum.
Sleep Timer Function
When the sleep timer is used, the power is auto-
matically turned off after the specified time has
elapsed.
1.
Press SLEEP to set the desired sleep time.
The SLEEP indicator and sleep time appear
in the display window.
2.
Each time you press SLEEP, the setting
changes in the following order.
SLEEP 180 → 150 → 120 → 90 → 80
→ 70 → 60 → 50 → 40 → 30 → 20 → 10
→ OFF (No display) → SLEEP 180 ...
Note:
If you press SLEEP while the sleep time is
displayed, the SLEEP time is reset.
To cancel the sleep timer mode
If you have to stop the function, press the SLEEP
repeatedly until "SLEEP 10" appears, and then
press SLEEP once again while "SLEEP 10" is
displayed.
Setting the Clock
1.
Press CLOCK.
2.
Select a 24 hour cycle or a 12 hour cycle by
turning MULTI JOG.
or
(12HR)
3.
Press SET to confirm the selected hour
cycle.
4.
Turn MULTI JOG on the front panel to set the
correct hours.
5.
Press SET.
6.
Turn MULTI JOG on the front panel to set the
correct minutes.
7.
Press SET and the correct time is shown on
the display window.
8.
Press CLOCK at any time, to display the time
for about 5 seconds.
Note:
If you want to reset the clock, press and hold
CLOCK for more than 2 seconds.
(24HR)
9