Assembling The F-100; Check The Parts; Assembly Procedure - Roland F-100 Owner's Manual

Introduction

Assembling the F-100

Make sure that another person is on hand to help with the assembly and setup.
To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you assemble and
move the piano, to make sure that you do not drop it on your hands or feet.
Always carry out this procedure with the F-100 lying horizontally, with the rear panel facing down.

■ Check the Parts

Before you begin assembling the F-100, check that all the
parts were supplied.
You will also need to have a Phillips screwdriver.
fig.st1
1
F-100
2 Speaker box
3
Side panel right and left
Rear
Front
Rear
Front
4 Pedal Board
Screw x 10
5
The speaker box can also be installed so that it faces toward
the rear instead of toward the front. Having the speaker box
face out the rear of the instrument allows the speakers to be
directed toward listeners when the back of the instrument
faces the audience.
fig.stsp
Normal direction
Front Rear
Speaker
box
6
Speaker cable
(Left)
Cross section
(Right)
6 Cap x 10
(and some spare caps)
When facing to the rear
Front Rear
Speaker
box

■ Assembly Procedure

• At first, assemble the entire unit in a temporary fashion,
without really tightening the screws.
Then, after checking the overall alignment of the boards
(and gently shifting certain parts where necessary), go
around and tightly fasten each of the screws.
• Be careful when assembling the F-100, so as to avoid
scratching the side panels.
When securing the screws, lay the entire unit sideways
with the rear side of the F-100 at the bottom.
1.
Tighten the screws on one of the side panels to
secure that side panel the F-100 and speaker box
(four locations).
Install so that the speaker cable at the rear of the speaker
box extends to the right side (the side where the F-100's
[Power] switch is located).
fig.st02-2
F-100
Speaker box
2.
Align the projection of the pedal board with the
hole in the side panel, and use a screw to fasten
the pedal board (one location).
fig.st02-2
Pedal Board
3.
Align the hole in the other side panel with the
projection of the pedal board, and use a screw to
fasten the pedal board (one location).
fig.st02-2
Side with
rounded
corners
Side panel
facing out
(Left)
Screw
Screws
Side with
rounded
corners
Side panel
facing out
(Right)
Screw