Panasonic KX-HN7001 Installation Manual page 6

Important Information
R Regularly remove any dust, etc. from the
AC adaptor/power plug by pulling it from
the power outlet, then wiping with a dry
cloth. Accumulated dust may cause an
insulation defect from moisture, etc.
resulting in a fire.
R Unplug the product from power outlets if it
emits smoke, an abnormal smell, or makes
an unusual noise. These conditions can
cause fire or electric shock. Confirm that
smoke has stopped emitting and contact us
at http://shop.panasonic.com/support
R Unplug from power outlets and never touch
the inside of the product if its casing has
been broken open. Danger of electric shock
exists.
R Never touch the plug with wet hands.
Danger of electric shock exists.
R Do not connect non-specified devices.
Installation
R To prevent the risk of fire or electrical
shock, do not expose the access point to
rain or any type of moisture.
R Do not place or use this product near
automatically controlled devices such as
automatic doors and fire alarms. Radio
waves emitted from this product may cause
such devices to malfunction resulting in an
accident.
R Do not allow the power cord to be
excessively pulled, bent or placed under
heavy objects.
R Do not mount the bracket in a location
higher than 2.2 m (7 feet 3 inches), in an
unstable location, in a location subject to
frequent vibration, or on a weak wall. (Do
not mount on gypsum board, concrete
blocks, wooden materials exposed to the
outdoors, walls with very rough surfaces, or
surfaces that are narrower than the width of
the wall mount bracket.) There is a risk of
injury if the product falls, or of fire or electric
shock if water enters the product.
R Keep small parts (microSD cards, screws,
etc.) out of the reach of children. There is a
risk of swallowing. In the event they are
swallowed, seek medical advice
immediately.
For assistance, please visit http://shop.panasonic.com/support
6
Operating safeguards
R Unplug the product from power outlets
before cleaning. Do not use liquid or
aerosol cleaners.
R Do not disassemble the product.
R Never put metal objects inside the product.
If metal objects enter the product, turn off
the circuit breaker and contact an
authorized service center.
Medical
R Consult the manufacturer of any personal
medical devices, such as pacemakers or
hearing aids, to determine if they are
adequately shielded from external RF
(radio frequency) energy. Wireless LAN
features operate between 2.412 GHz and
2.462 GHz with a peak transmission power
as following:
– Access point: 200 mW
– Front door camera/Outdoor camera:
100 mW
R Do not use the product in health care
facilities if any regulations posted in the
area instruct you not to do so. Hospitals or
health care facilities may be using
equipment that could be sensitive to
external RF energy.
CAUTION
Installation and location
R Never install wiring during a lightning storm.
R Although this camera conforms to the IPX5*
code, do not intentionally expose it to
water.
*IPX5 indicates that the product is
protected against water jets: water
projected at all angles through a 6.3 mm
1
( / inches) nozzle flow rate of 12.5 liters/
4
minute at a pressure of 30 kN/m2 for 3
minutes from a distance of 3 meters (9 feet
10 inches).
R Although this camera conforms to the IP6X*
code, do not intentionally expose it to grit
and dust.
*IP6X indicates that the product is
protected against grit and dust: this product
has shown the capabilities of preventing