Panasonic KX-HN7001 Installation Manual page 29

Installing the outdoor camera
1
Open the interface cover (A), and then
slide the power slide switch to ON (B) .
2
Close the interface cover (C).
3
Secure the safety wire ring to the camera
nut of the camera using a driver (D), and
then pass the safety wire through the ring
of the safety wire ring (E).
4
5
1
3
Important:
R Make sure to close the interface
cover securely. Water resistance
cannot be assured if the interface
cover is open.
For assistance, please visit http://shop.panasonic.com/support
4
2
Drive the wall mounting screws into the
wall.
1
Longer than 25 mm (1 inch)
2
1
Space 2.8 mm ( / inches)
8
1 2
Note:
R Use the following template when
determining the location of the screw
holes.
25.4 mm
(1 inch)
Setup
29