Operating Basics; Turning The Recorder On; Continuous Recording - Mio MiVue R Series User Manual

Operating basics

Turning the recorder ON

Complete the installation according to the instructions in the "Using your recorder in a
vehicle" section. Once the vehicle engine is started the recorder automatically turns on.
ƒ When the vehicle engine is turned off or the recorder's power is disconnected, the
recorder automatically saves the recording and turns off.
ƒ When a GPS fix is established, the GPS signal icon (
corner of the screen*.
ƒ Occasionally you may need to perform a hardware reset when the recorder stops
responding or if it appears to be "frozen" or unresponsive. To restart the recorder press
RESET.
* For selected models only.

Continuous recording

By default the system will automatically begin with continuous recording in a few seconds
after start up. The recording may be divided into several video clips; recording will not stop
between video clips.
ƒ When continuous recording is in progress, you can stop recording by pressing REC/OK.
When the recording stops, press REC/OK again to start recording manually.
CAUTION:
ƒ DO NOT remove the memory card while recording.
ƒ If continuous recording is ongoing but there is not enough space on your memory
card, new video clips will replace the old ones.
) will show on the top-right
7
en