Configuring The Recorder; Recording Settings - Mio MiVue R Series User Manual

Configuring the recorder

While the recording is in progress, press REC/OK to stop recording. Then, press MENU to
open the Settings menu.
ƒ Press MENU repeatedly to cycle through the menu screens: Recording settings (
> System settings (
ƒ Use the / button to select the desired option.
ƒ Press REC/OK to confirm change; press MENU to cancel selection.

Recording settings

ƒ Video Resolution: Sets the resolution of the video.
ƒ Video Quality: Sets the video quality to S.Fine, Fine or Normal.
ƒ Meter Mode: Sets the exposure metering mode to Center, Average or Spot.
ƒ Stamp Setting: Sets the information (date, time and driver's name) that will be
displayed on the video.
ƒ AE bias: Sets the proper exposure level to adjust the brightness of the image.
ƒ Video Clip Length: Sets the length of each video clip for a continuous recording.
ƒ LDWS Detect: Enables or disables the LDWS (Lane Departure Warning System) function.
Once enabled, the system will alert the driver when it detects that the car has strayed
from its intended lane (such as changing lane during driving).
ƒ LDWS calibration: After the LDWS function is enabled, follow the steps below to
calibrate the system.
1. Drive the vehicle in the middle of the lane.
2. Use the /
MODE and then repeat the step to align the bottom line with the front edge of the
car's bonnet.
) > GPS settings (
button to align the top line with the horizon. When done, press
).
9
en
)