Important Note - Roksan Audio Kandy KMA-2/3 User Manual

Multi-channel A/V Connection
Using the Kandy DVD, Kandy Integrated Amplifier and Kandy Power Amplifier 3-channel:
CONNECTION NOTES:
1. Connect Front Main L & R speakers to the Integrated Amplifier L & R speaker outputs
2. Connect Rear (Surround) L & R speakers to the 3-Channel Power Amplifier L & R speaker outputs
3. Connect Centre speaker to the 3-Channel Power Amplifier C speaker output
4. Run Test Tone on the Kandy DVD player and manually adjust Integrated Amplifier volume until all speakers sound
equally loud (Remember or mark this volume setting for future reference when using in multi-channel A/V mode. The
Integrated volume would normally be around 3 O'clock with similar sensitivity loudspeakers used for front, centre and
rear. To adjust overall listening volume level in this mode, use the Kandy DVD volume control and not the Integrated
volume control)
•
If Centre speaker is too loud, then connect the DVD centre output to the Trimmed input C on the 3-Channel Power
Amplifier and adjust Level Trim C until the sound level is equal with the other speakers
•
If Rear speakers are too loud, then connect the DVD Rear L & R outputs to the Trimmed inputs L & R on the 3-Channel
Power Amplifier and adjust Level Trim L & R until the sound level is equal with the other speakers

Important Note:

When using a stand-alone surround sound processor connect only to the Straight Inputs on the Kandy
Power Amplifier and use the processor's level trim.
Roksan Audio ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
Kandy Power Amplifier 2/3 Channel User Manual
Page 7 of 10
Kandy DVD Player
Kandy Integrated Amplifier
Kandy Power Amplifier 3-Ch
ENGLISH
Set-up
Version 1.0