Specifications - Rockford Fosgate Punch X150.1 Installation & Operation Manual

S
PECIFICATIONS
MODEL
Peak Power Rating - Measured at 14.4 Volts
Mono into a 2Ω Load
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4 Volts
Mono into a 4Ω Load
Mono into a 2Ω Load
Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts
RMS continuous power mono, driven into a
4Ω load from 20 to 20,000Hz with less than
0.05% Total Harmonic Distortion (THD)
RMS continuous power mono, driven into a
2Ω load from 20 to 20,000Hz, with less than
0.1% Total Harmonic Distortion (THD)
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Dimensions
Frequency Response
Bandwidth
Damping Factor @ 4Ω (at output connector )
Slew Rate
IM Distortion (IHF)
Source Unit Compatibility (+15dB gain overlap)
Input Sensitivity (+0dB gain overlap)
Protection
Battery Fusing Rates (External to Amplifier)
Fuse Type
Equalization (45Hz Punch Bass)
Input Impedance
Specifications subject to change without notice
10
PUNCH X150.1
400 Watts
110 Watts
190 Watts
75 Watts
150 Watts
>100dB A-weighted
24dB/octave Butterworth
variable from 50Hz to 250Hz
2.60" (6.60cm) H
9.60" (24.38cm) W
6.70" (17.01cm) L
20Hz to 20kHz ±0.5dB
10Hz to 200kHz ±3dB
>200
30 Volts/ms
<0.05%
17V max. (low level in)
Variable from 250mV to 4V (low level in)
Variable from 650mV to 11V (high level in)
NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
15 amps
ATC
Variable from 0dB to +18dB @ 45Hz
20k ohms