MSI MS-98H3 Manual page 47

MS-98H3
▶ Terminal Type
To operate the system's console redirection, you need a terminal supporting
ANSI terminal protocol and a RS-232 null modem cable connected between
the host system and terminal(s). This setting specifies the type of terminal
device for console redirection.
▶ Bits per second, Data Bits, Parity, Stop Bits
This setting specifies the transfer rate (bits per second, data bits, parity,
stop bits) of Console Redirection.
▶ Flow Control
Flow control is the process of managing the rate of data transmission
between two nodes. It's the process of adjusting the flow of data from one
device to another to ensure that the receiving device can handle all of the
incoming data. This is particularly important where the sending device is
capable of sending data much faster than the receiving device can receive
it.
▶ VT-UTF8 Combo Key Support
This setting enables/disables the VT-UTF8 combination key support for
ANSI/VT100 terminals.
▶ Recorder Mode, Resolution 100x31
These settings enable/disable the recorder mode and the resolution
100x31.
▶ Legacy OS Redirection Resolution
This setting specifies the redirection resolution of legacy OS.
▶ Putty Keypad
PuTTY is a terminal emulator for Windows. This setting controls the numeric
keypad for use in PuTTY.
▶ Redirection After BIOS POST
This setting determines whether or not to keep terminals' console redirection
running after the BIOS POST has booted.
3-19